Perfect Pass not holding speed

(driver_dad) · (driver_dad) **Join Date: Oct 2006** 08-21-2007, 7:29 PM

Lately, my Perfect Pass has been inconsistent holding speed. It works fine for a few runs but then it tends to speed up or slow down like it disengages. I have to turn it off, then on again once or twice to get it to hold speed again. Any recommendations?

(wakedad33) · (wakedad33) **Join Date: Oct 2005** 08-21-2007, 7:43 PM

If your running a lot of extra ballast, try changing it to RPM mode, it helps sometimes.

(jmv) · (jmv) **Join Date: Aug 2005** 08-21-2007, 11:36 PM

Had it happen to me too--when I had my boat. It's the paddle wheel underneath the boat. It gets banged up when you load the boat onto your trailer by hitting the support beam. It cost a $100 shipped and is pretty easy to replace.

alanp 08-22-2007, 1:55 AM

i would perform a master reset on the unit. refer to you owners manual

(dudeman) · (dudeman) **Join Date: Mar 2005** 08-22-2007, 2:31 AM

Mine was searching and still is all of the time. It never disengages though. It varies 5 mph. It was the cable setup. Had the dealer call PP about a warranty upgrade after reading a post here and mine fell into the warranty upgrade status. It will be upgraded to DBW next week. If you're not DBW, you may want your dealer to check for you.