The solo driver will be getting close to 60% of the RMS wattage as the total load is only 4 ohms there. The wattage is going to go down the path of least resistance, in this case the single driver. The other crcuit will be getting whatever is left over as it has a total load of 8 ohms. That is a very unbalanced wiring schema and you should purchase another sub or a 1 ohm stable amp. You will probably also get cancellation. So while the amp will be fine, it will not perform like you want it to. The proper way to wire those three subs to that amp would be to run 1 sub on one channel, and run the other two parallel (2 ohm load) on the other channel. (Message edited by Olskooltige on April 18, 2007)
|