Hello,
I am new here and I really need some help from some veteran DIY people. I am about to install a custom setup in my 20v Riders Edition Tige. The drawing below shows how I want to lay it out. Please let me know if you see any problems with this setup. I want a fully electronic system so that I could adjust water going into and out of each ballast. One question I do have though is how does the water keep from coming out of the drain line while you are filling? I will be using a total of 6 attwood 1200gph pumps and 3 electronic water valves. I have not purchased anything yet as I am out of the country. I was wanting to make sure that everything would work before I started buying the stuff. Any help would be appreciated. Please email me at
justin_rolltide@hotmail.com popjpeg{430840,Upload}