Just fitted an Amp and two speaker in my boat and two Polk tower speakers. We are running the boat speakers off the head unit direct and are running the tower speakers from the four channel amp. We are going to bridge the amp, does anyone have pics of there amp bridged or diagrams of how to do it correctly so as not to damage the amp. We will be running about 80 RMS per speaker on the tower when the amp is bridged. We were also playing around with the setting but are not really sure where to start. Would anyone have any pointers how to set up the Amp? There is two switches one for the 1-2 channels and the same for the 3-4 channels switch with three settings High Freq filter, LOW freq filter and Full. Then there are dials for the high level freq, low level freq, and bass boost again for channel 1-2 and 3-4. Can anyone give us advice as how best to set it up to throw the sound the furthest or even a good starting point for the setting to get the best sound out of the speakers.
|