drilling your glass: Measure THREE times, cut once. Lay it all out so you know EXACTLY where things need to go. You don't want to have to stick a cupholder where you F'd up. but that's a good cover-up IF its flat enough
For small holes (up to 1/2") drilling forward doesn't hurt at all. Use painters tape to keep splintering to a minimum. Take it SLOW.
Reverse drilling is for hole saws. Just in case you ever need to, here's how: tape off like above. run saw in reverse for AT LEAST 1/4 of inch below the surface. then forward drill to finish it off. I usually run it all the way through in reverse, but forward can save you some time
I'd think about wiring the tower when you install, whether tower speakers are in your immediate plans or not.
Have fun!!
Last edited by denverd1; 05-27-2016 at 9:49 AM.
|