I've got a question:
My tower speaker connectors are as pictured below, and my amplifier obvioulsly just has the regular phillips screw connector block on the side of the amp.
1. How do these NLT4 and NLM4 connectors work with my tower speaker hookups?
2. Should I cut them off near my amp and just screw down the wire?
3. How many pairs are in the wire? I need two pairs, one for each tower speaker. I have two tower speakers.
4. What's the diameter of the finished product with and without the end connectors? We have to drill holes in our boats and in the tower possibly to feed the wire through and if it's too fat, that's not a good thing, right?
In addition, here's a little gem I found from another post on MBO that I'm using as my thru-hull fitting to feed my wire out of the hull and into the tower. Go to:
www.danamarineproducts.com and search for "Bilge Dump".
Thanks,
John