Just tint it yourself. Really isn't that hard, just watch some vids on YouTube to get a feel for it. All you need is the tint, a spray bottle with warm soapy water, a razor knife, and a rubber squeegee. Just spray the outside of the glass with the soapy water and lay the tint out on it, cut it to size and trim it for the shape/curve of your windshield, then pull it off. Next spray the inside of your windshield with soapy water, peel the clear backing off the tint (painters tape works well, tape a piece to each side facing each other and leave a tab, the peel the painters tape apart and it should split the films). Then spray the tacky side of the tint and put it against the inside of the glass. The soapy water will keep it from sticking too hard and allow you to move it around until it's in the proper place. Then use the squeegee to smooth it out and pull the water out from between the tint and glass. Trim as needed to get a tight fit against the edges of the frame, and then let it sit for a couple days in the sun to fully cure the adhesive.
|