Do I need an extra On/Off switch with this?

This is the setup I am going with. Other than fuses at the distribution block (for the amps) do I need to worry about power draw (when not in use? Should I add an inline switch / Breaker for this?

Also, What size power wire and fuses should I use? Amp1: JL 1000/1, Amp2 JL300/2, Amp3 90wx4. I may add a 4th amp in the future.

I run the exact same Blue Sea system, I use thermal breakers on the batts to totally disconnect.

(Message edited by Razzman on February 13, 2009)

I'm with rassman, use some sort of breaker.

Don't use a switch.

The last 2-3 JL amps I've had, always drew power when they were off??? Never could figure it out. The amps always worked fine.

I thought it might be due to the fact you dont; necc. need a remote wire for turn on, they can be turned on via the RCA's ( voltage sensing)

Sweet, thanks. What size breaker?

Will this work? The largest I see in these is 150A. This is a Blue Sea.