I had ordered new exhaust, risers and gaskets from Skidim. While assembling yesterday, I noticed how "off" the riser gaskets were from the castings. Both on the manifolds and the risers. Nothing lined up perfectly and there was up to a 1/8" difference in some if not all the alignments. I completed the install, but after sleeping on it, I'm not cool with this situation.
I really feel the best way to do this is to make my own riser gaskets. The difficulty on this task should be very low.
What gasket material does everyone recommend for this application? Should I go with a regular Fiber based material, Cork, Copper RTV or something else?
Thanks
|