I installed a 4 outlet heater. 2 euro vents 2 hot tubes. Just about everyone that trys the heater almost immediatly mentions that the flow is pretty low. With two euro vents closed, one hot tube closed, and one open it's decent, but open 2 tubes and one euro vent and you can barely feel any flow if you put your hand 6 inches from the tube. On the other hand i have no heat output issues at idle speed. It actually keep cranking 5 mins after i shut the engine off! Any thoughts, is this weak flow normal? Their 40,000 BTU claim seems to be complete crap. I used a 15 amp fuse as required and actually hooked it up to a dedicated accessory wire that supplies 20 amp.
|