Our original dash began to crack around all of the mounting points and the original switches were having problems not staying. That was two years ago. At that point, I made a new dash panel out of some abs black plastic and installed some rocker switches to go with it.
It looked kinda cheezy since most trimming was done with a dremel. My brother is a machinist and machined out a new plate, actually two one for each side, to hold all of the switches, breakers and stereo control.
Its nice having it in two pieces, so you dont have to remove everything to get one side way out.Its a little dirty, lots of dust. Made from 1/4 aluminum all rounded painted gloss black. Its so much nicer than the plastic version.
Linear Mode
