You just need to make sure you have the right shaft diameter and degree of strut.those are the 2 things that need to be the same as the one you took off.
I just did my 03 Tige for example1 1/8" shaft with a 16 degree angle.Not sure what your boat would be ..but thats what you need to know.Good Luck.
You need to take a look at the shaft to make sure its straight. I didnt even know mine was bent until i started taking on water because the strut being bent pushed my shaft over about 3/4" where it comes through the boat and it wore my shaft seal and caused a leak.So take a look at that too and make sure it didnt get damaged.
I got lucky and the shaft was not bent just pushed over..but you do need to make sure its not bent.