I have a 2010 Watson Hybrid and I messed up one of my fins the other day...
the fin that came with the board is labled the XLR 0.8 Fin.
So I go to the store to get the XLF 0.8 replacement fins... but when I get home, i realize that the 2 fins are totally different...
the one that came with the board have only 3 small screwholes, but the one i just bought has 4 large screw holes...
the large screws wont even fit in the board, and to make things worse, even if I was able to fit the large screws through the board, the fin sits in a different position further out towards the end of the board...
Whats up with that??
You'd think that all XLR 0.8 Fins are the same....
anyone have this problem??
Last edited by Eden; 07-13-2010 at 5:43 AM.
|