I have a few hundred lbs of wheels weights and im planing on melting them down. What I'm wanting to do is make a long (36 inch) brick size (3 inch high) mold to pour the lead into. Ideally, I would like for it to be flat on one side and have a 90degree angle at the other (so it can fit snugly against a wall.) I'm wanting to run this piece/pieces on the floor down the side of my engine cover. My question is, could I make this out of plywood? Any ideas of anything else I could use? If this is not possible, what could I use as a mold for a long brick shape. Thanks
|