Yes. I have a '96 Sanger and replaced the rollers a couple years ago. We have a trailer store nearby. I either found the rollers there or at my local Sanger dealer. I don't recall which one, but I know I didn't have to look too far. I did try a set of generic rollers from a marine store (west marine??) and there was a problem with the width of the hub. My trailer has about a 5/8" - 3"4" shaft for the rollers and they are held on by a kotter pin. The hub on the rollers from West Marine were too thick, so they would not slide far enough on to get to the kotter pin holes. Just something to look for.....I found this dimension sort of difficult to measure with the rollers on the trailer.
|