I have an 06 Outback V and I cannot figure out how to remove my bilge pump. It is an attwood sahara 500 I think. The light on the switch will not go off,,,the pump makes no noise when I flip the switch and there is water in my boat. I have figured out that my tube was clogged up, would that cause it to maybe burn up? Any suggestion?
|
anyone?
|
the bottom part of the pump is black and acts as a screen. Their are taps on both sides of the screen. Press them in and the pump part will lift off with the wires. <BR> <BR>Check the fuse first, the screen does not let the hose clog but if the float switch gets stuck on the pump will run continuously until it dies. <BR> <BR>If you buy the same model to replace you can leave the base part and just clip the new pump on to it.
|
WAlove is right - you have to squeeze the clips on each side and the upper white part will pop off. The Sahara also has a knob on the side for testing the float switch, but I bet the motor is cooked. I just replaced a Sahara 500 about a month ago that was only a couple years old. <BR> <BR>FWIW, I'd go with a 750 gph when you replace it. 500 gph bilge pumps are really intended for 17' LOA and under, not to mention the additional risks from ballast.
|
All times are GMT -7. The time now is 5:00 PM. |