lakesurfer |
06-06-2010 4:36 PM |
Edgar
1. Take out the rear and mid hard tanks and plug in 1,500lb Enzo sacs on each side (it is plug and play. If you have the mid tanks make sure there are two in/outs/over flows. If not have them install them so you can fill with both the rear and mid tank plumbing). This will give a nice wave. If you want it bigger add weight to the seat and a little weight to the nose. I know a few guys that run 300lbs in the opposite rear tank. They say it add a lot of push to the wave.
3. If you are running on the regular side, run with the wake plate level with the transom. If you are running on the goofy side, run with the wake plate all of the way down (you will need a trim tab or Switch Blade to clean up the goofy wake on Enzo)
2. go to www.centurioncrew.com. Very helpful site and the question has been answered in detail
Good Luck!
|