Can you mount any binding to the board ? I bought A roam today and want to mount my ronix cells to it. Do you guys know if there will be a problem with this?
|
no there shouldnt be. i mount my ronix ones on my roam but you may need to put an extra washer on the screws
|
I had no trouble w/ any boot
|
I remember reading something about you were supposed to use the Hype screws... But I think it is like Billy F says.. you may need washers. I use LF bindings and like the spring loaded flip locks.. I have 05 and 08 Roams with this set up.. No probs on 05.. anxious to use 08
|
the board is thinner so you need to make sure you have the right length screws. the board should have come with the correct size screws.
|
what they said^^^^^
|
Jason is exactly correct. The board requires a specified screw. It comes with the board. I found this out after i bought it, and used regular length thumb screws and broke a binding off on my first set. After a call to Hyperlite they filled me in on the screw length thing. After i got me a few of those, i've taken alot harder falls on it, and theres been no problem.
|
My first Roam didn't come with the shorter mounting screws, so I had to size some at the hardware store. My second and third came with the correct screws. <BR> <BR>I see the older Roams in pro shops w/o the screws still, so it is possible to buy a new board w/o them. I'm sure hyperlite would send them to you, if you need them.
|
All times are GMT -7. The time now is 4:47 AM. |