Articles
   
       
       
Pics/Video
   
       
       
Shop
Search
 
 
 
 
 
Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
WAKE WORLD HOME
Email Password
Go Back   WakeWorld > Boats, Accessories & Tow Vehicles

Share 
Reply
 
Thread Tools Display Modes
Old    Dan Allbagh (masterwake1122)      Join Date: Jul 2010       07-20-2010, 9:50 AM Reply   
Took my 97 nautique sport out after I had the drive shaft pin put back in place.

Ran it for about 15 minutes or so and ran fine. Shut it down and decided to float for a while.

Went to go start it back up and it didn't do anything. Opened the engine compartment key on engine off and I could hear the low pressure fuel pump wind, the stereo was working, blower on, all guages worked (battery showed regular).

What gives? Starter cylinoid? Fuse? I don't get why it ran fine for a while and then nothing.... wasn't choppy water so it's not like it was bouncing around and some wires could have been jolted...
Old    Baitkiller (baitkiller)      Join Date: Jan 2010       07-20-2010, 10:18 AM Reply   
Neutral safety safety switch? They can be tender and the wiring would be vulnerable to collateral damage when one is massaging the drive line. If you have dash power but no click the issue will likely be found at the assist solenoid and / or neutral switch.

Follow yellow / red and black / yellow to your destiny.

Hope it helps.
Old    Dan Allbagh (masterwake1122)      Join Date: Jul 2010       07-21-2010, 1:30 PM Reply   
I will check it out. Where would the assist sylinoid be and how would I check either of these to see if it's the problem? Thanks for the response.
Old    Dan Allbagh (masterwake1122)      Join Date: Jul 2010       07-23-2010, 12:00 PM Reply   
I messed w/ the throttle and put it back to neutral and it started.... guess I will have to find out where that neutral safety switch / mechanism is to make sure it's okay.... hopefully it doesn't strand me again.
Old    Steven (stu929)      Join Date: Jun 2010       07-23-2010, 12:10 PM Reply   
Mine is mounted on a valve cover. Im sure we do not have the same motor but I would look up top of the motor.

Reply
Share 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On



All times are GMT -7. The time now is 1:59 PM.

Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
Wake World Home

 

© 2012 eWake, Inc.    
Advertise    |    Contact    |    Terms of Use    |    Privacy Policy    |    Report Abuse    |    Conduct    |    About Us