Articles
   
       
       
Pics/Video
   
       
       
Shop
Search
 
 
 
 
 
Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
WAKE WORLD HOME
Email Password
Go Back   WakeWorld > >> Boats, Accessories & Tow Vehicles Archive > Archive through September 10, 2007

Share 
Reply
 
Thread Tools Display Modes
Old    James (styk33)      Join Date: Aug 2004       09-03-2007, 6:57 PM Reply   
I am looking for a little help here. I am trying to replace my rudder on 2000 V210 and I am having some problems getting the rudder out of the boat. Does anyone have experience with this and can help out. I cannot get the rudder down through the hull. It looks like I can push it down, but it does not move much.

[img]http://i62.photobucket.com/albums/h84/Styk33/DSCF0485-1.jpg[/img]
Old    Luciano Grimblat (luchog)      Join Date: Jun 2002       09-03-2007, 7:25 PM Reply   
can you say hammer???
Old    James (styk33)      Join Date: Aug 2004       09-03-2007, 10:29 PM Reply   
I used a hammer gingerly as I did not feel comfortale pounding with all my might on the bottom of my boat.
Old    Nate (norcalmalibu)      Join Date: Jun 2004       09-03-2007, 10:53 PM Reply   
I just replaced the rudder in my 99 v210



first you need to unhook the steering linkage, then unbolt the four bolts. Next you might need to get putty knife and start separating the bottom plate from the boat as it is stuck on with marine epoxy.

Pull the whole assembly out from inside the boat, on my boat I had to remove the muffler tubes on the left to get it out.

To install the new one you need to jack the boat up on the trailer.
Old    James (styk33)      Join Date: Aug 2004       09-04-2007, 9:08 AM Reply   
Nate, thank you. I was hoping that I did not need to do that :-(

I have the exhaust tubes out already for easier access.
Old    Robert Thorson (thor)      Join Date: Oct 2001       09-04-2007, 9:31 AM Reply   
James,

I had to replace the rudder on my Sanger DLX and I had the same problem with the rudder not dropping out through the hull after I had removed all of the linkage. I tried to gently persuade the rudder with a hammer but this ended up causing the end of the rudder to mushroom making it impossible to push through the hull. We ended up cutting the rudder off right below the hull, and then pushing the rod up into the boat.

Good Luck.

Reply
Share 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On



All times are GMT -7. The time now is 1:18 AM.

Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
Wake World Home

 

© 2012 eWake, Inc.    
Advertise    |    Contact    |    Terms of Use    |    Privacy Policy    |    Report Abuse    |    Conduct    |    About Us