2008 Faction Hinge question

is it very difficult to tighten the hinge up on these? The right one seems a smidge looser than the left, and i was gonna tighten it up, is it that difficult? should i take it to the shop or what

No it's very simple, look at it & you'll figure it out.

(Message edited by pri3st on September 04, 2008)

Kiley, on the cable part where it attaches to the binding on the bottom there is an eyelet hole held in with a screw, remove the screw and you will see that you can thread in and out the eyelet hole. clockwise makes it tighter counter makes it looser

I have torques that are doing the same thing. It doesnt seem like its the hindge though, seems more like the top part with laces are stretching. When i got them the laces would pull tight, now the left one pulls all the way tight but the binding is still slightly loose. Can I replace the top par with the laces?

On the 08 boots the cable adjusts on the bottom not like the 07 being on the side.
Just take the boot off the board and there are 2 cables with nuts on the bottom. that is where you adjust them.
It only takes a little.

Yep, Lyon has it.

Rob, your local pro shop should have extra strings and lace locks. I believe the torque still uses the older laces/locks. See if you can get a set of the 08-up stuff for your torques. It works very well.

will do thanks jarrod

Rob, contact CWB for replacement laces and locks. They sent replacments to me, no questions asked. Good customer service.

really, i will do that, thanks mike k, appreciate it