Underwater LED install pix

(mikeski) · (mikeski) **Join Date: Aug 2003** 07-05-2009, 10:27 PM

Finally made the time to install my underwater LED. Wasn't too bad once I drilled the big countersunk hole in the center. Used a 3/16" bit all the way through then a 1/2" countersink bit to give it plenty or room for the 3M 4200 sealant to bed in.

I chose to run a single high power LED opposite my single exhaust. I think it looks very balanced on the back of the boat. Have not had it in the water at night yet, maybe next weekend?

Enjoy

Upload

(ajholt7) · (ajholt7) **Join Date: Apr 2009** 07-06-2009, 12:51 AM

Looks nice. Will be looking for the on water shots. Is that a bullet lines?

(ricabernathy) · (ricabernathy) **Join Date: Jun 2009** 07-06-2009, 9:25 AM

what is that down pipe coming from the exhaust? and where did u get the leds?

(ajholt7) · (ajholt7) **Join Date: Apr 2009** 07-06-2009, 1:43 PM

That is a Fresh Air Exhaust on his exhaust.

(ricabernathy) · (ricabernathy) **Join Date: Jun 2009** 07-06-2009, 2:40 PM

I just looked up the "Fresh Air Exhaust",does it really make a diffrence mikeski? its 450 for my boat..

(hatepain) · (hatepain) **Join Date: Aug 2006** 07-06-2009, 2:48 PM

I was expecting to see pics of you in scuba gear installing that thing.

Ric, yes it makes a huge difference.

Ben Kerran 07-06-2009, 3:39 PM

Mikeski- I'm more impressed that you were allowed the time to work on a project :-)

Hope all is going well!!

(mikeski) · (mikeski) **Join Date: Aug 2003** 07-06-2009, 10:36 PM

Ben, I had to cash in some chips to get the time... I did it in less than 2 hours including cleanup, the switch is currently zip tied under the dash as I ran out of time to install it permanently. Need to wait until the pile of chips builds up again.

Yes, Fresh Air Exhaust makes a big difference. I like it, my wife really really likes it, she says it is the best upgrade I have done to the boat.

It's the Bullet X8000 in blue.