Oh the sea cast stuff is the sh*t. Better than wood, the only thing that i caution is to drill the proper holes for your mount bolts and give it plenty of time to cure and set. I also used lag bolts as anchors and drove them into the rear and forward part of the stringer to tie it all together. motor was solid as a rock. Then all you have to do once it is in there at the same level as the stringers were before is glass over it. This is where it sucks because you have to glass over and over and over and over and over again sheet by sheet. I cheated and after ten sheets I used kitty hair to fill it in then ran about 5 more strips over that. All in all it looked awesome, no one could tell and it held just fine. Man i still have some of that stuff left hahaha, i wonder if it is any good still. Maybe i will make a seacast ice chest holder hahaha
|