Project Phlaunder charity board

well i got it in the water on sunday and it rode great fast and quick. check out the art on bottom and the vid. was real choppy on the lake.
http://s99.photobucket.com/albums/l295/saltyoysters/?action=view&current=lakewakescom_08640.flv

Sweet! It looks great!

How about some pictures of the board?

ok

uhhh, files tooo big. i have some posted on other sites , you know!!!!!!!!!

(Message edited by lakeside5_10 on May 27, 2008)

put some pix on my photobucket

LESSONS LEARNED ARE.

(1)only use paint on the core then lam , never paint then hot/glosscoat because of fear of fisheyes.
(2) make sure to move your project inside when bad weather shows up , i did not think i would get rain mist sprayed on the board after a hotcoat but i did.
(3) get ricepaper artwork in before you lam , and do not install as part of hotcoat , you will just to do it again to burry the paper.
i used 2.5 qt of epoxy mix on this project and should have used about 1.5 total . with all of the rework i had to do these were lessons learned,

The surfboard building gods reward every mistake with an hour or so of sanding.