Stupid roam board question

(sdmjr) · (sdmjr) **Join Date: Jul 2007** 02-09-2008, 6:46 PM

Can you mount any binding to the board ? I bought A roam today and want to mount my ronix cells to it. Do you guys know if there will be a problem with this?

(mcwakerider) · (mcwakerider) **Join Date: Dec 2006** 02-09-2008, 7:05 PM

no there shouldnt be. i mount my ronix ones on my roam but you may need to put an extra washer on the screws

(sidekicknicholas)

I had no trouble w/ any boot

(04outback) · (04outback) **Join Date: Jul 2007** 02-10-2008, 5:54 AM

I remember reading something about you were supposed to use the Hype screws... But I think it is like Billy F says.. you may need washers. I use LF bindings and like the spring loaded flip locks.. I have 05 and 08 Roams with this set up.. No probs on 05.. anxious to use 08

(westsidarider) · (westsidarider) **Join Date: Feb 2003** 02-10-2008, 2:40 PM

the board is thinner so you need to make sure you have the right length screws. the board should have come with the correct size screws.

(nickdakoolkat) · (nickdakoolkat) **Join Date: Sep 2005** 02-10-2008, 5:03 PM

what they said^^^^^

(hawkeye7708) · (hawkeye7708) **Join Date: Feb 2007** 02-10-2008, 6:09 PM

Jason is exactly correct. The board requires a specified screw. It comes with the board. I found this out after i bought it, and used regular length thumb screws and broke a binding off on my first set. After a call to Hyperlite they filled me in on the screw length thing. After i got me a few of those, i've taken alot harder falls on it, and theres been no problem.

(elantz) · (elantz) **Join Date: Jul 2006** 02-11-2008, 7:52 AM

My first Roam didn't come with the shorter mounting screws, so I had to size some at the hardware store. My second and third came with the correct screws.

I see the older Roams in pro shops w/o the screws still, so it is possible to buy a new board w/o them. I'm sure hyperlite would send them to you, if you need them.