Recently added an arc 600.2 to power my 4 REV 10s. I've been doing some tuning but I'm not sure if my installer has the right settings. I myself put the frequency around 70hz, have the button out for X1 setting, set on high pass, I have the gain about 3/4 of the way up and it's running to an WS-420SQ. The speakers are ran parallel so should the amp be set on stereo, bridged, or mono L R ? This speakers sound awesome but I'm a sound junky and probably going to add another 600.2 to get them at 400watts a piece instead of 300. Another quick question. If i do add the second 600.2 how do I wire things up and what setting would the amp be in to get the 4 ohm 400watts per speaker?
Thanks!
|