BINDINGS FOR RONIX FRONTIER

(deadger) · (deadger) **Join Date: May 2007** 09-14-2007, 5:32 AM

i just bought my wife a new 137 Ronix Frontier, and was wondering if Ronix boards accept only ronix bindings / boots or will a set of Hyperlite or Liquid Force bindings also fit this board. In the past I have ran into issues with Hyperlite bindings not turning out to be such a good fit with Liquid Force boards, and was questioning if the same pertains to Ronix!!!

thx.

(texastbird) · (texastbird) **Join Date: May 2003** 09-14-2007, 5:46 AM

Any brand will fit. Well, not Slingshot, but the rest should bolt right on. My gf is riding a Ronix Covin with some Gator bindings and it is working fine.

(wondermike) · (wondermike) **Join Date: Apr 2006** 09-14-2007, 6:44 AM

slingshot makes a plate that will adapt their boots to other boards.

(sidekicknicholas)

I needed different screws for my hyperlites to fit... the regular claw screws were too long, but Obrien screws fit fine

(hawk7) · (hawk7) **Join Date: Apr 2007** 09-14-2007, 9:40 PM

any brand would fit but the errington setup would be cool. my murray claws fit into my one just fine.

(Message edited by hawk7 on September 14, 2007)

(wakemitch) · (wakemitch) **Join Date: Jun 2005** 09-14-2007, 10:12 PM

if the screws are too long just use some washers.

(sidekicknicholas)

My murrays were to long for the ibex