xti conversion/rival

finally got the boat in the water

went with the through hull similar to the engines, instead of rivals 1.5" scoop

doesn't look great, but no other place to put it

put the ball valve in and then plumbed with pvc to the switch

have 2 bags in the bow
1 one the rear drivers side

then on the passenger side, I went with fly highs quick connect
the hoses roll up and fit in the netting and behind the panel when not in use

in the rear center
I did away with the ice chest
fiberglassed some plywood, and covered it with carpet...making a new floor


I was originally going to make a new seat
but decided to creat a hinged door that can hide hoses when not in use
or quick connect 2 fly high bricks when I want ballast

the rear area is still a project in motion
I might make a more stable "wall"
also, the switch panel will more than likely be abs plastic..in the future
..I am going to add Malibus fill/drain dash swithches in place of accessory swithes...in the future

in the rear center
I did away with the ice chest
fiberglassed some plywood, and covered it with carpet...making a new floor


I was originally going to make a new seat
but decided to creat a hinged door that can hide hoses when not in use
or quick connect 2 fly high bricks when I want ballast

the rear area is still a project in motion
I might make a more stable "wall"
also, the switch panel will more than likely be abs plastic..in the future
..I am going to add Malibus fill/drain dash swithches in place of accessory swithes...in the future