Anyone know where I can find pulleys to upgrade a 351 Ford to dual pulleys of different widths or some configuration that will allow for a 3/8" belt on the impeller and a 1/2" or dual belts on the alternator? Is this even possible? Thanks.
Grant had to have his machined. I do not think you will find the correct pulleys anywhere. I believe the cost for two custom machined billet pulleys was in the $800 range.
Mike is correct: Caesar is having the same pullys made right now. A good machine shop can take your factory pullys and re make them with the belt sizes you need thats what I had done
Linear Mode
