Perko flush pro on a super air 210

I looked up some of the past threads and did not find what I was looking for. Can anyone help me out!

I have a correct craft super air 210 with the pcm excalibur 330 engine. I have the perko flush pro but my problem is there is not enough room to put it near the strainer. I was checking to see if I could put it closer to the back of the boat near the raw water intake propeller. I see those two hoses and they would be easy to get to. Any pics would help out greatly. Thanks

I have an 05 210 with the excaliber and i just installed a flush kit.

I had to:
-remove the portion of hose between the strainer and temp sensor.
-remove the temp sensor and cut another 4 inches off past it
-replace temp sensor
-put 4" piece of hose on to connect the temp senser to the flush
-put 4" piece on flush kit to connect to strainer

...I will post pics tomorrow.