Alright I have been putting the new system together this off-season and its time for install. I am concerned about interference. Specifically I am trying to decide how I should run my power wire. I have a 99' Mastercraft 230 (v-drive), the battery is mounted (stock) in the back port-side corner (inside boat, not in engine compartment). My amps are going to be mounted under the dash. I can run the power wire around the back of the boat, or run it straight up around the port side and around the bow. It would be cheaper to run it in the back since it would require less wire, but I am not sure about interference. Does anybody have any experience with this? Where is the best place to ground? Also, I am about to add a second battery-any suggestions?
|