I just finished up installing Perfect Pass on my 04' Tige 21i with the 6.0L Marine Power motor. When I turn the key on, (not starting though), the screen lights up, but nothing happens besides it pulses every 10 seconds. I spliced in at the ignition switch for the power. Idk if it has enough power there to operate the PP, because when I found the hot wire with my test light, the light was pretty weak. Anyone have any info on the best place to get power from?
2nd question is the RPM wires. There is 3 studs coming out of the back of the tach. 1 Purple wire, 1 pink, and 1 black. I hooked the black one up to the ground wire of my RPM wires. then the gray wire for the RPM, went to the purple wire, which was the hot wire with the key on and my test light grounded on the prong with the black wires. With my ground to my test light on the ground at the ignition, the black wire at the tach is hot when the key is on! Im so confused on where to hook stuff up under there. Mayb I should just give up on it for tonight, and try again tomorrow. Any help would be great. If we cant figure it out, I guess I will be calling Canada in the morning