|
I want to re do the traction on my walker project bullet.
What is the best way to pull off the old traction and get all the glue and stuff off without damaging the board?
I tried to pull a couple pieces off and used a heat gun on low but was so hard, I said to heck with it and put a piece back on.
It is clear that just pulling it off with not work and I will have to use some sort of glue remover.
It is a walker bullet with the X-Trax traction.
Help! I want to re do the board before summer as I do not like the way I did my traction
Tim
Wet Sounds
|
Threaded Mode