Hyperlite bindings---------Ronix board????

(wake175m5) · (wake175m5) **Join Date: Jun 2007** 07-25-2007, 10:15 AM

about to order the the RONIX IBEX but i want to hold off on bindings till them come out with them, i have HYPERLITE PARKS bindings right now. are they compatible?

(premier136) · (premier136) **Join Date: Jul 2006** 07-25-2007, 10:27 AM

yes they are...i use the one bindings on my hyp premier

(1boarder_kevin)

I currently ride a 3DS with the Cell boots and they are compatible so I would assume that the other way would work as well

(kurtbwr) · (kurtbwr) **Join Date: Jul 2007** 07-25-2007, 11:54 AM

Kevin - How do you like your 3ds? I ride a belmont and love it, but its seen its days. Just lookin for some input..

(committed) · (committed) **Join Date: Jul 2005** 07-25-2007, 12:41 PM

Ones married to a Platty Transcend.

(qball) · (qball) **Join Date: May 2007** 07-25-2007, 1:26 PM

Just to expand the question - do most bindings fit most boards? I would like to fit CWB hinge techs to a Byerly board... thanks and sorry for the hijack Beecher.

(committed) · (committed) **Join Date: Jul 2005** 07-25-2007, 1:41 PM

For the most part, Sean, yes. Make sure if your going to match up bindings, you do a testfit first. I have hinge-techs, and they are massive in size. Depending on your deck, they can go side to side on the board. Great bindings, just BIG bindings.
They haven't changed the bolt patterns yet, so almost all will matchup in some form or another, unless it's a Slinger......

(1boarder_kevin)

Kurtis,
I like the 3dS a lot. It Is a fast board that goes out into the flats. Change the fins and it still will cut hard, but will loosen up a little.

(yeldarb) · (yeldarb) **Join Date: Jul 2006** 07-25-2007, 4:23 PM

I have Hyperlite Proof bindings on a Ronix One board. They fit, but I had to put washers under the screws because the Hyperlite screws were too long for the holes and wouldn't tighten enough without adding the washers.