Tower Speaker Wire Recommendations

I need to wire up my tower speakers, so I need two pair of wires. Looking for a nice heavy duty wire that is bundled together and doesn't look like lamp cord. I do not need any connectors.

Any links would be appreciated. Will be driving 2 Fusion T-Series Combos at 2Ohms @225RMS.

thanks

I am using 14/4 CL3 speaker cable. It is 14 ga high strand speaker cable, 4 conductors. It is all in one jacket, about 10mm in dia. I bought it from www.mcminone.com I can give you a part number when I get home, it was 33$ for 100ft. Actually, I'll have about 75 ft extra when I'm done that I could sell you cheap if you want it.

Im not sure I would want to run 225 watts threw wires this small but it might not bother you, this stuff looks cool, check and see how much power you can or should push threw this gauge
http://www.lightningaudio.com/2004/products/product.asp?prodID=837

John,

Here is a link to the stuff I was telling you about:
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=3767921140

I was very happy with it the first time around and will be using it again. Send them a message they made up a custom harness to my specs. Good people to work with and they know thier stuff. They supply lots of cabling for pro-audio use.

Home depot, 10/4 so or sjo. only comes in black.

Thanks everyone. I think I'm going with the stuff that Mike recommended because the jacket is black and they will make a custom cable for me.

John,

Tell them not to put the shrink wrap on the ends or to make it short otherwise you will need to trim it yourself.

Mike

I would have too, had I seen those first! I'm gonna use the same connector anyway.