just wondering i bought a pair of skylon rubicon 350's and am wondering is it best to wire them in at two ohm, or 4 ohm. I have a alpine pdx 4.150 150 watts rms at each channel running at two ohm or 4 ohm or so stated on box. thanks
Looking at Skylon's website, your speakers are 3 ohm each. So with your amp, I would run one speaker bridged to channel 1+2 and the other speaker to channels 3+4 Mono the inputs.
With your speakers wired bridged mono, the amp is 300 watts x2. That is plenty of power. Check with Alpine to make sure the amp will run stable below a 4 ohm load.
Linear Mode
