stretching the wrap on bindings

i just rode my 04 nice RG1 bindings for the first time and the wrap on them was way extreme. they were real hard to get in and out of. they have 2 laces and a rachet on them to make them snug and I was just wondering if it would hurt anything to try and stretch the wrap out a little bit to make them easier to get in and out of and if it wont hurt anything does anyone have any suggestions on how to do this? thanks

well first see if you can make them bigger whitch you probaly already did and after that mold them to your feet and they should be alot more confy and mabye a little looser. to do this you just take a blow driier and heat up your bindings till the rubber is like kinda stretchy and really soft, then get sope and put your foot in it when its still hot and leave your foot in them for like 5 minuts. after that youll like your bindings alot mre, but make sure to brake them in first , like so there not so stiff,

sweet i had never thought of that
break them in before molding them with the hair drier? how long does it take to break them in like how many sets do you think? and do i just heat up the pads at the bottom or like the wrap and all? thanks for the help

Make sure you keep them connected to the board. I put my new boots on lose and it took me fifteen minutes to pry them off of my feet.