blown speaker

Was going to bridge my amp this weekend and was looking to get some diagrams as to how to do it. just dont want to blow up the speaker. Any pics or diagrams welcome.
Rob

How many channels is the amp?

Also, on most amps if you look at the power and ground spots where you screw in the speaker wires it will have something written on there like this:

|- bridged -|
[+] [-] [+] [-]

or the other way around.

sorry if that was confusing.

Need a lil more info, perhaps which amp you have, and how many channels.

(Message edited by norcalbrdrydr on April 13, 2006)

The amp is a four channel pyle amp and we are running just the tower speaker 2no from it

Take your + wire and attach it to the + of the first channel, your - wire and attach it to the - of the second channel. The same for the third and fourth if you are hooking up another speaker.

If you look on the amp it should say bridged and then 2 lines indicating to you which positive and negative to use for bridging.