2 Wetsound Pro 80's 1 Kicker zx450.2 Specs of amp are: Amplifier Class AB Number of Channels 2 RMS Power (4 ohms) 150 watts x 2 channels RMS Power (2 ohms) 225 watts x 2 channels RMS Power (1 ohm) N/A Bridged RMS Power 450 watts x 1 channel Peak Power Output N/A Minimum Impedance Unbridged 2 ohms Minimum Impedance Bridged 4 ohms THD at Rated RMS Power 1% Speaker Level Inputs Yes Preamp Outputs Yes - 1 pair Built-in Crossover High-pass (HP), Low-pass (LP), Full (AP) High-Pass Crossover Frequency 50 - 200 Hz Low-Pass Crossover Frequency 50 - 200 Hz Subsonic Filter N/A Signal-to-Noise Ratio 95 dB Channel Separation N/A Bass Boost 0 - 18 dB Bass/Gain Remote Yes Fan Cooled No Fuse Rating 30A x 2 Do i bridge these to get my amp at two ohms or what? Please be detailed its been awhile since i worker with audio. One more question I have a kicker 4 channel running my six cabin speakers. I have it hooked up like this 2 Front speakers + - + - Thats on 2 channels of the amp. Rear ++ -- ++ -- is on the other two channels. That sound right?
|