I need some help!
I Have the following audio gear that i need some help setting up.
Fusion IP500 Headunit
Kicker KX850 Amp (4 channel)
Fusion Fe402 amp (170 rms)
2 wetsounds XS650 for the cockpit
2 Kicker KMT6 for the tower
12" Fusion Sub
I have installed it all and wired it up properly.
I have 4awg power and ground cables going to each amp via a fused distribution block.
At the moment I only have a single battery and a 65amp alternator. I know that the alternator will get trashed if i run the system for any legnth of time at high volume as it simply cant put out enough power. I dont play the stereo when im not boarding or cruising. I board on the sea so safety and reliability from the battery and alternater is very important.
My question is this-
I know i am going to have to install a dual battery setup but what can i do to prevent overloading the alternater and trashing it?
|