Articles
   
       
Pics/Video
       
Wake 101
   
       
       
Shop
Search
 
 
 
 
 
Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
WakeWorld Home
Email Password
Go Back   WakeWorld > >> Boats, Accessories & Tow Vehicles Archive > Archive through April 04, 2003

Share 
Reply
 
Thread Tools Display Modes
Old    xwake            03-01-2003, 1:47 PM Reply   
Hi all,

I was wondering if anyone out there could take a few pictures of the Aluminum manifold that the Intake from the Thru-hull scoop feeds into to supply water to the 3 pumps in your system?
My email address is b_jago@hotmail.com or you could just post them here. That might be better anyway. Someone else might benefit as well.

I have been able to take a pretty close look at the MC ballast system in a friends 2002 X-star (Thanks Jerry!) but I wasn't able to get a good look at the manifold. In his boat the manifold is located on the bottom of the hull in the engine compartment in the Rear left, but you should be able to follow the intake line to wherever the manifold is installed. Although, I figure they are all installed the same. I'm probably going to try and make my own, so I would like to be able to see where the holes are located.

Any help would be greatly appreciated.

Thanks,


-Bo

Reply
Share 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On



All times are GMT -7. The time now is 4:59 AM.

Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
Wake World Home

 

© 2016 eWake, Inc.    
Advertise    |    Contact    |    Terms of Use    |    Privacy Policy    |    Report Abuse    |    Conduct    |    About Us