Hi All
I am looking for some advice, on the best wiring method for the equipment as shown. I hope that it is clear enough for you to understand, and this is how I have it currently running.
At first I was going to just run two speakers and a sub, then I realised it was not enough. Since then, I've purchased the extra two speakers and also now the 4x tower speakers, and will mount and connect those tonight. So far, I'm reasonably happy with the performance, but now I'm looking for some options on how to tweak for better performance/power etc.. I'd like to be able to at least hear the music when I am riding. I'm sure some audio guru here will tell me I've wired this wrong and could get better performance some other way.
Currently I have 4 x Polk MM651s, all running separately in parallel to the front channel of XS4600. Then, I have the sub running bridged over the single rear channel.
After that, I have these 4 tower speakers (brand unknown, as they came in the pods) and would like to run them from the XS4300. There are only two wires running up the tower (one wire will run 2 speakers - not ideal but I can change it if needed), so I will simply bridge each wire over the front & rear channels respectively and I presume this will supply 75w RMS to each speaker. The speakers are only 60w RMS.
Thanks in advance for all replies and advice,
Wiring Diagram:
Phoenix Gold specs: