Ronix Cells on LF Watson - Issues?

(robertgwi) · (robertgwi) **Join Date: Apr 2010** 05-05-2010, 11:54 AM

If I am putting 09 Cell boots on an 09 Watson board, am I going to have issues with the Ronix binding screws / cam locks?

(jason95gt) · (jason95gt) **Join Date: May 2006** 05-05-2010, 4:08 PM

If the boots are a size 10, you are going to have lots of problems and should sell them to me.

They are fine, just might need a spacer/washer if the screw is to long.

(hawkeye7708) · (hawkeye7708) **Join Date: Feb 2007** 05-05-2010, 4:34 PM

http://www.wakeworld.com/forum/showthread.php?t=778954

I posted this up a few days ago... didn't get much for hits, but this chart should answer your questions pretty well!

(hawkeye7708) · (hawkeye7708) **Join Date: Feb 2007** 05-05-2010, 4:36 PM

From what I can see, there shouldn't be any issues as far as stance options go. Both use a 6" pattern, boot and board. Might be a SLIGHT screw depth discrepancy, but more than likely, they'll work just fine with screw depth and you WILL have all the stance options.

(robertgwi) · (robertgwi) **Join Date: Apr 2010** 05-05-2010, 7:27 PM

Ha - Thanks for your help. They are a 10. If for whatever reason they don't work out for me, I'll shoot you a message.

(ironj32) · (ironj32) **Join Date: Jan 2007** 05-06-2010, 6:57 AM

works just fine...i rode that setup last year.

(stang_killa_ss)

i had to grind a 1/16" off the end of the screws, for some reason most ronix screws are too long for LF board inserts. i had to do this for my 09 reliks on 09 watson. i know several other guys on WB.com had to do the same with ronix on LF