|
Here we go, another trailer owner dissatisfied with the extra weak jack that came stock.
I would like to replace it with a Fulton Jack, but without having to weld on an additional mounting plate.
The existing pad (shown below) measures about 4 inches square, with a 7 hole bolt pattern.
There are 4 holes with centers on the corners of a 3 inch square. Then there are 3 more holes in a centered column with 1 inch between centers.
Is there anyway to bolt on a Fulton Jack to this pad ... with or without an adapter? (and I assume, if possible, it will take an adapter.)
Thanks,
John
|
Threaded Mode