Articles
   
       
       
Pics/Video
   
       
       
Shop
Search
 
 
 
 
 
Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
WAKE WORLD HOME
Email Password
Go Back   WakeWorld > Wakesurfing

Share 
Reply
 
Thread Tools Display Modes
Old    Danny Smylie (smylie)      Join Date: Jun 2002       05-20-2006, 9:47 AM Reply   
So i just got my surf skate from Trickboardz. I ordered it with fins so that i could get used to riding with fins at the start and be able to take them off later.

Heres the deal. The board is drilled with holes at each end for the fins. the 2 outside holes are not fully drilled because they are the female receptor for the 2 male plugs on the fin itself. The middle hole that is needed for the screw to go from the top to inside the fin is cut through, but the padding on top of the board is covering it up. What should i do?
thanks,
Danny
Old    Shane Lafferty (pickle311)      Join Date: Oct 2005       05-20-2006, 7:41 PM Reply   
I would poke a small screwdriver through it or something like that so that it doesn't rip the padding, but will poke a hole in it, then screw on your fins
Old    Larry Mann (niap101)      Join Date: Jul 2004       05-28-2006, 4:20 PM Reply   
Danny
We are supposed to cut that hole before it leaves the factory. I had to fill in for an absent employee and I probably forgot to do that; my bad.
Poke a small hole, like with a sharp pencil, from the bottom, then push the screw down from the top. Work it a little and you will clean the hole out.
Larry Mann
Trick Boardz

Reply
Share 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On



All times are GMT -7. The time now is 5:29 AM.

Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
Wake World Home

 

© 2012 eWake, Inc.    
Advertise    |    Contact    |    Terms of Use    |    Privacy Policy    |    Report Abuse    |    Conduct    |    About Us