right now i have a '02 xstar with a pair of b530's already hooked up. i just bought a set of B60's and was wondering the best way to run more wire through the tower.
this is gonna be hard to explain, but i will try. this is what i was thinking i might do.....
1. make the existing hole on the top of the tower (where the wire comes out) a little bit bigger so that i could run another wire through the same hole.
2. take some new speaker wire (with a very long string attached to it) and tie it to the end of the existing speaker wire (unhook it from the B530's).
3. pull the existing wire from the bottom of the tower until the new wire gets through the bottom also .
4. at that point, tie the two wire together at the same ends (the string is currently running all the way through the tower) and pull both wires back to the top.
think that will work? also, has anyone taken the tower of of a '02 mastercraft and actually seen how the wire runs into the hull? will there be room to run more wire?
or there was another post showing how somebody hooked the tower speakers up to each other. will that work? here is the post? http://www.wakeworld.com/MB/Discus/messages/3183/50176.html
any opinions or other helpful hints would be great
(Message edited by mossy44 on March 31, 2003)