I was wondering if anyone out there could take a few pictures of the Aluminum manifold that the Intake from the Thru-hull scoop feeds into to supply water to the 3 pumps in your system?
My email address is firstname.lastname@example.org
or you could just post them here. That might be better anyway. Someone else might benefit as well.
I have been able to take a pretty close look at the MC ballast system in a friends 2002 X-star (Thanks Jerry!) but I wasn't able to get a good look at the manifold. In his boat the manifold is located on the bottom of the hull in the engine compartment in the Rear left, but you should be able to follow the intake line to wherever the manifold is installed. Although, I figure they are all installed the same. I'm probably going to try and make my own, so I would like to be able to see where the holes are located.
Any help would be greatly appreciated.