Articles
   
       
       
Pics/Video
   
       
       
Shop
Search
 
 
 
 
 
Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
WAKE WORLD HOME
Email Password
Go Back   WakeWorld > Wakeboarding Discussion

Share 
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old     (bboozer)      Join Date: Apr 2007       07-22-2012, 4:07 PM Reply   
I have plans for a floating 12" corrogated pipe slider project, but I have a few questions for those that have some experience with these. I have two pieces that total about 16' and i have a plan to attach them in the middle and seal the joint and the ends. Then I was thinking that i would just put and anchor on each end. This would allow the pipe to rotate, would that matter? Also, I was planning on using my old 08 Murray board to slide it, but it has molded in fins and i am wondering if that wouldn't cause it to hang up on the corrogated areas and cause a nasty fall. Since I have no experience with hitting sliders, I am just looking for advise and/or suggestions.
Attached Images
 

 
Share 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On



All times are GMT -7. The time now is 7:40 AM.

Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
Wake World Home

 

© 2012 eWake, Inc.    
Advertise    |    Contact    |    Terms of Use    |    Privacy Policy    |    Report Abuse    |    Conduct    |    About Us