Articles
   
       
       
Pics/Video
   
       
       
Shop
Search
 
 
 
 
 
Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
WAKE WORLD HOME
Email Password
Go Back   WakeWorld > Wakesurfing

Share 
Reply
 
Thread Tools Display Modes
Old     (silverlude)      Join Date: Apr 2004       08-07-2013, 10:22 AM Reply   
Can't find any epoxy repair nearby for needed nose repair of IS Swallow board. Would it be ok to use JB Weld? I have regular fiberglass resin but it always seems to just chip away and have to do it over again. Need it for Friday as the board was dropped on tip and now chipped and cracked again. Ordering a epoxy kit will take too long to get here so need something I can find at hardware store. Thanks
Old     (Chaos)      Join Date: Apr 2010       08-07-2013, 12:08 PM Reply   
Brian, sand with 80 to 100 grit paper, and then clean the area with ethanol or isopropyl alcohol. Get a two part clear kit at the hard wear store, slower is better.... the 30 minute type will yellow less than a 5 minute cure epoxy. Your inland is epoxy laminated, but usually has paint on the surface with a clear coat or gloss.

Nick

Reply
Share 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On



All times are GMT -7. The time now is 1:15 PM.

Home   Articles   Pics/Video   Gear   Wake 101   Events   Community   Forums   Classifieds   Contests   Shop   Search
Wake World Home

 

© 2012 eWake, Inc.    
Advertise    |    Contact    |    Terms of Use    |    Privacy Policy    |    Report Abuse    |    Conduct    |    About Us