I got some Neutrick baseplates and connectors. I've got a drill. I need to put a hole in my boat... just wanted to run the process through with you guys for no other reason then confidence.
First, Drill holes in the tower (two at top) and one on each base leg.
Use a string and vacuum and suck the string through the holes (starting at top and threading to bottom) for both set of holes.
Run speakerwire through the tower (keeping it loose).
Put on the neutricks connectors at the base and the tower (for my Pro 80s).
Put Duct Tape on flat section of boat for base plate.
Drive Hole through Duct Tape and Fiberglass (in "reverse" for drill.
Remove Duct Tape.
Place Nuetricks Baseplate in hole, drill in screws to hold in place.
Connect Neutricks Baseplates to existing speaker wires.
Connect Neutricks Connectors - Turn up Stereo and Enjoy.
Do these steps seem logical?